Saw User Manual

Section B: The application example as demonstration

system

I t lli

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 30/107

Manual_SIMOTION Flying Saw_V1.4.doc

4.4.3 Re-configuring the double-axis motor module from 3A/3A to 5A/5A

This application example is configured as standard using a 3A/3A motor

module. However, there are demonstration cases in the field, which are still

equipped with a 5A/5A motor module. The hardware should be carefully

checked before the project is downloaded! If a 3A/3A motor module is not

used in the demonstration case, then the project can be re-configured by

following the subsequent instructions:

• Go offline

• In the project tree, open the “Drive Navigator”

• A selection window opens when the “Device configuration” button is

pressed

• Open the Configurator by pressing the “Execute drive configuration"

button

• Scroll in the selection menu of the power unit by pressing the

“Continue” button

• Select the power unit being used from the list – refer to the serial

number on the front of the double motor module, e.g. 6SL3120-2TE15-

0AA0 (5A/5A)

• Press “Continue” and acknowledge the alarm messages

• Press the “Continue” button – without making any additional changes –

until the “Complete” button appears; also press this

• Close the Device Configurator

• In the Expert list of the red and blue drives (select the particular drive ->

righthand mouse key -> Expert -> Expert list), reduce parameter p210

from 600V to 345V

• Compile and save the project, go online and load the project into the

target system