Saw User Manual

Section B: The application example as demonstration

system

t lli

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 26/107

Manual_SIMOTION Flying Saw_V1.4.doc

Table 4-1 Hardware components

Hardware element Diagram Order No./MLFB and functions

Training case, SIMOTION D435 with SINAMICS S120

SIMOTION D

demonstration and

training case

6ZB2 470-0AE00

The SIMOTION D training case comprises

standard components (SIMOTION D435,

two SINAMICS axes with motors) and has

two axes. These are used to demonstrate

the application.

The case is already pre-configured and

connected-up. It only has to be connected

to the HMI system via PROFIBUS.

Communications

PROFIBUS connector

up to 12 Mbit/s

6ES7972-0BA41-0XA0

The connector is used to establish a

connection between the HMI system and

the SIMOTION D435 training case

PROFIBUS cable

6XV1830-0EH10 (sold by the meter, from

20m)

The cable is used to establish a connection

between the HMI system and the

SIMOTION D435 training case

HMI system

PG/PC with MPI

interface

The PG/ PC is used as the HMI display

screen.

Procedure

Please proceed as follows to configure and install the hardware

components for the application example: