Saw User Manual

Section A: Prerequisites and objectives

Structure and function

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 20/107

Manual_SIMOTION Flying Saw_V1.4.doc

3.2 Operating states of the "FlyingSaw-FB"

The “FlyingSaw FB” automatically controls the “flying saw” axis to

implement the required level of functionality.

This functionality is sub-divided into five operating states so that the

sequences at the “flying saw” are implemented as a result of the states or

also as a result of the transitions between the states.

This means the user only influences the “flying saw” by specifying the

required operating mode with the required parameters.

Fig. 3-2 Operating modes

Disable

Startposi-

tion

Startposi-

tion

Manual

Error

Auto-

matic

Auto-

matic

A differentiation is made between the following operating modes:

• Error (0)

The “FlyingSaw FB” has detected an error and brought the flying saw

axis into a safe state. The fault is still available and the user can

evaluate it.

The flying saw axis is stopped and is in the “disable” state.

• Disable (1)

The “FlyingSaw FB” is already being used but is in the safety operating

state. All of the faults/errors present have been successfully

acknowledged.

After a reset, the flying saw axis is in the disabled and stopped state.

• Starting position (2)

The flying saw axis moves to the starting position or is located at the