Saw User Manual

Section E: Appendix

Error messages

Flying Saw with SIMOTION A4027118-A0414

V 1.4 Release 06/06/08 101/107

Manual_SIMOTION Flying Saw_V1.4.doc

12 Error messages

12.1 Signaling error events at the “FlyingSaw FB” of the core “flying

saw” functions

If an error occurs when calling the “FB_BGD_TEMPLATE_FlyingSaw()” of

the core “flying saw” functions, then this is displayed using an error code at

output

ErrorID of the FB.

If the error is caused by a TO-specific command called from the Flying Saw

FB, then its

RetDINT or FR is documented in the data area FS_Var for

evaluation by the user.

12.2 Possible error messages at the error code output ErrorID of the

„FB_BGD_TEMPLATE_FlyingSaw()“

A reference is made to the internal block error source of the “FlyingSaw FB”

in the

Explanation column.

Table 12-1 Error codes of the flying saw template

ErrorID

error code

Explanation

C001 There is an error at a flying saw axis

C005

Position of the flying saw axis greater than that specified under

UsersInterface.g_r_EndPos.

C011 Disable to Disable

Error when stopping the FlyingSawAxis ( _stop )

Details in FS_Var structure under RetDINT_stop_FSA

C012 Disable to disable

Error when stopping the FlyingSawAxis ( _stop )

Details in FS_Var structure under FR_stop_FSA