Technical data

Commissioning

4.11 Sending an E-mail from a SIMATIC CPU

TS Adapter IE Basic

Manual, 08/2014, A5E02615140-03

4.11

Sending an E-mail from a SIMATIC CPU

Function block for sending e-mail

To send an e-mail from a SIMATIC CPU, you can use the AS_MAIL, TM_MAIL or TMAIL_C

function blocks, depending on the CPU type.

You can find additional information about the AS_MAIL, TM_MAIL and TMAIL_C function

blocks in the online help for the respective block.

An e-mail cannot be sent

If the you cannot successfully send an email, refer to section "Not possible to send e-mail

(Page 63)".

4.12

Reset configuration with the Web interface

It may be necessary to reset the configuration if the adapter parameters on a remote system

have been altered such that you are no longer able to access the TS Adapter IE Basic via

the modem connection.

Requirements

● Your PG/PC is connected directly or by modem via an active remote connection to the

TS Adapter IE Basic.

● You are logged on as an administrator.

Procedure

Note

If you reset the configuration of the TS

Adapter IE Basic, all the parameter settings you

made will be lost.

1. Open the "Actions > Parameter Set > Reset" tab in the Web interface.

2. Click "Reset Parameters".

Result

The TS Adapter IE Basic is reset to its default configuration in the factory state.