Manualshelf

Technical data

ManualsBrandsSiemens ManualsNetwork CardSIMATIC PC Adapter TS Adapter
31323334353637383940
Commissioning
4.6 Establishing a Remote Connection to the TS Adapter IE Basic
TS Adapter IE Basic
Manual, 08/2014, A5E02615140-03
37
4.6.3
Establishing a Remote Connection to the TS Adapter IE Basic via a Dial-up
Connection
Requirement
You have connected and put into an operation a modem or ISDN TA on your PG/PC.
Procedure (Windows 7
®
)
1. Connect the TS Adapter IE Basic via a phone cable to the phone network.
2. Connect the TS Adapter IE Basic to the power supply.
3. Commission your local modem on the PC as set out in the modem manual. Also install
the drivers for the modem.
4. Select "Start > Control Panel > Network and Internet > Network and Sharing Center > Set
up a new connection or network > Set up a dial-up connection" and confirm with "Next".
5. Select "Connect to a workplace" and click "Next" to continue.
6. Select "Set up dial-up connection" and click "Next" to confirm.
If only one device is available on your PG/PC, continue with step 8.
7. Select the device via which you want to connect and click "Next" to confirm.
If you are using an ISDN TA, select a device with the B-channel protocol X.75. Disable all
other devices.
8. Enter a name for the connection and click "Next" to confirm.
9. Enter the number of the TS Adapter IE Basic and confirm with "Next".
10.Select who is to use the connection and click "Next" to confirm.
11.Enter the user name and password to log on to the TS Adapter IE Basic and click "Next"
to confirm.
12.Click "Finish" to save the connection.
13.Select the newly created connection under "Start > Settings > Control Panel > Network
Connections".
14.Click "Select" to start connecting.
15.If you want the TS Adapter IE Basic to call you back, enter the number of your local
modem in the "Callback" window. Always click "OK" to confirm the "Callback" dialog box
anyway.
The existing connection is maintained.
When shipped, the TS Adapter IE Basic is configured such that in most cases the remote
connection setup is successful. If you are unable to establish a remote connection, refer to
the section "Error diagnostics (Page 55)". It may be the case that you have to first change
the settings of the TS Adapter IE Basic in the direct connection in order to troubleshoot.