Technical data

Commissioning
4.5 Setting IP Parameters of TS Adapter IE Basic for the First Time
TS Adapter IE Basic
Manual, 08/2014, A5E02615140-03
31
4.5
Setting IP Parameters of TS Adapter IE Basic for the First Time
In the delivery state and after resetting the parameters, the TS Adapter IE Basic will not have
an IP address (0.0.0.0). To be able to work with the TS Adapter IE Basic, you must first set
its IP parameters. The IP parameters are set:
● By direct connection with the TIA Portal (Page 31)
● By direct connection with TeleService (Page 32)
● By direct connection with the SIMATIC Manager (Page 33)
● Via remote connection with TeleService (Page 43)
● Via remote connection (Page 44)
If you are unable to establish an Ethernet connection or a remote connection, refer to the
"Error Diagnostics (Page 55)" section.
NOTICE
Password change
To protect the TS Adapter IE Basic against unauthorized access, the first time you log on
you should always replace the preset "admin" password of the default user "Administrator"
with a new password (the default user "Administrator" cannot be changed).
4.5.1
Setting IP parameters by direct connection with the TIA Portal
Requirement
You have a LAN connection to your TS Adapter IE Basic.
You have installed TIA Portal V11 or higher.
The TS Adapter IE Basic is connected to the power supply.
Procedure
1. In project navigation for the TIA Portal, select the menu command "Online access>
<Ethernet interface>".
2. Double-click on the "Update accessible participants" command.
The list of accessible participants is updated.
3. Select TS Adapter IE Basic (participant [0.0.0.0]).
4. Double-click on the command "Online & diagnostics".
5. In the working window, select the menu command "Functions > Assign IP address".
6. Enter the IP address you want and the subnet mask and click on the "Assign IP address"
button.