Technical data

Commissioning
4.4 Connecting the TS Adapter IE Basic
TS Adapter IE Basic
30 Manual, 08/2014, A5E02615140-03
4.4
Connecting the TS Adapter IE Basic
Note
If you connect the Ethernet plug to the ISDN slot of the TS
Module ISDN, this will lead to a
malfunction of the TS
Adapter IE Basic.
Only conn
ect the Ethernet cable to the Ethernet port of the TS Adapter IE Basic.
Connecting to PG/PC
The direct connection of the TS Adapter IE Basic to PG/ PC is only required for configuration
of the TS Adapter IE Basic.
1. Plug the Ethernet cable into the Ethernet port on the TS Adapter IE Basic.
2. Plug the other end of the Ethernet cable into the Ethernet port of your PG/PC or onto a
switch that your PG/PC is also connected to.
Connecting to the automation system
1. Plug the Ethernet cable into the Ethernet port on the TS Adapter IE Basic.
2. Plug the other end of the Ethernet cable into the Ethernet port on your CPU or to a
switch.
Connecting to 24 V DC
The TS Adapter IE Basic is intended for 24 V voltage only. The TS Adapter IE Basic is
powered via the infeed plug. Wire the supplied 24 V plug as described in section " Power
Supply (Page 20)" and plug it into the TS Adapter IE Basic. Ensure the correct plug
orientation.
Note
Ensure that the 24
V supply cable is fused as appropriate for its cross-section.