Technical data

Commissioning

4.3 Setting the PG/PC Interface

TS Adapter IE Basic

Manual, 08/2014, A5E02615140-03

4.3

Setting the PG/PC Interface

Procedure

Note

This chapter is only relevant for classic applic

ations. Users of the TIA Portal do not use the

PG/PC interface.

During installation of the software you are prompted to set the PG/PC interface.

1. Open the "Set PG/PC interface" dialog box to verify it.

– If "TS Adapter IE" interface is included in the selection list, go to step 5.

– If "TS Adapter IE" interface is missing from the list, continue with step 2.

2. To add or remove interfaces, click "Select...".

The "Install/Remove Interface" dialog box opens.

3. Select the "TS Adapter IE" module from the selection list and install the adapter.

4. Click "Close" to close the dialog box.

5. In the "Set PG/PC interface" dialog box select the TS Adapter IE.

6. Click "Properties...".

The "Properties - TS Adapter IE" dialog box opens.

7. Open the "Local Modem" tab.

8. Under "Modem:" choose the modem with which you want to connect to the

TS Adapter IE.

9. Depending on the module used, select the following settings:

– With a connection to an ISDN module, select the B channel log X.75, e.g. AVM ISDN

SoftCompression X.75-V.42bis.

– With a connection to a GSM module, select the B channel log V.110 with a maximum

transfer rate of 9600 bit/s, e.g. AVM ISDN Custom Config.

10.Under "Location > Name:" choose the location of your PG/PC. Click "Edit" if needed to

open up the "Phone and Modem Options" dialog box to set up a new location. For more

information on the location, refer to the help for the "Edit location" dialog box.

11.Click "OK" to exit the "Properties - TS Adapter IE" dialog box.

If you have changed an access path in these settings, a warning message then appears. To

apply the changes, click "OK".