Technical data

Commissioning
4.2 Overview
TS Adapter IE Basic
28 Manual, 08/2014, A5E02615140-03
4.2
Overview
Commissioning options
The TS Adapter IE Basic has a Web interface that can be used to set the parameters of the
TS Adapter IE Basic.
In the delivery state and after a parameter reset, the IP parameters of the
TS Adapter IE Basic are set so that remote maintenance and e-mail are not possible.
The following table shows an overview of the various options for commissioning the
TS Adapter IE Basic into operation:
Step
Commissioning ...
... By direct connection via an
Ethernet connection
... Via remote connection with
TeleService or with the TIA Portal
... Through a remote connection
without SIMATIC software
1 Set IP parameters by direct
connection:
• With the TIA Portal
• With TeleService
• With the SIMATIC Manager
Establish remote connection:
• With the TIA Portal
• With TeleService
Establish remote connection:
• With a remote network
2 Open Web interface in direct
connection:
• With the TIA Portal
• With TeleService
• With a browser
Open Web interface using a
remote connection:
• With the TIA Portal
• With TeleService
Open Web interface using a remote
connection:
• With a browser
3 Configuration for remote maintenance or e-mailing
4 Carry out remote maintenance or send e-mail
Details about the individual commissioning tasks can be found in the following subsections.