Technical data

Connecting

3.3 Ethernet Port

TS Adapter IE Basic

24 Manual, 08/2014, A5E02615140-03

Remove system plug

1. Press the position on the system plug marked with ③ in order to release the lock.

2. Pull out the system plug (

④).

The support collar can remain on the TS Adapter IE Basic . With a support collar you can

also use a cable with a RJ45 plug according to ISO/IEC 8877:1992.

Note

If you confuse the Ethernet connector with the ISDN connector for the TS

Module ISDN, the

Adapter IE Basic will malfunction.

Make sure the Ethernet cable is connected only to the Ethernet port of the

Adapter IE Basic.

Note

The

specifications relating to interference immunity and interference emission apply only

when using lines and connectors conforming to industrial requirements in accordance with

EN 61000

-6-4:2007 and EN 61000-6-2:2005.

Note

Place a short strain relief dev

ice for the Ethernet cable underneath the TS Adapter IE Basic,

securing it by a cable tie to an S7

300 shield mounting element for example.

Pin assignment and signal description of Ethernet port X1

Figure

Pin number

Signal name

TX+

TX–

RX+

4 –

–

RX–

–

8 –