Technical data

Connecting

3.2 Power Supply

TS Adapter IE Basic

Manual, 08/2014, A5E02615140-03

Wiring the connectors

To change the voltage, proceed as follows:

1. If you want to use ferrules, isolate the wires to 10 mm. Cap the crimp ferrules with the

lines.

Strip about 8 to 10 mm off the wires.

2. Place the cores on (

①).

3. Screw the ends of the cores with the voltage, tightening torque: 0.6 to 0.8 Nm (

②).

L+

24 V DC

Ground

Ground connection

Figure 3-2 Change the voltage

Plug on voltage

place the wired voltage ① until it locks into the power socket. Ensure the correct plug

orientation.

①

Voltage

Figure 3-3 Plug voltage on TS Adapter IE Basic.