Specifications

Error diagnostics

8.8 Error diagnostics - Ethernet

TS Adapter IE

80 Manual, 06/2008, A5E00977705-02

8.8 Error diagnostics - Ethernet

8.8.1 You do not know the IP address of the TS Adapter IE.

Remedy

Follow the procedure described in the section "Set IP parameters by direct connection with

TeleService", steps 1 through 7.

See also

Setting IP Parameters by Direct Connection with TeleService (Page 46)

8.8.2 The TS Adapter IE is not accessible via Ethernet

Remedy

1. If the Link LED is not lit, first check the Ethernet cabling.

If the Link LED is lit, move on to step 2.

2. Proceed as described in the following chapters:

– "Set IP parameters by direct connection with TeleService"

– "Set IP parameters by direct connection with the SIMATIC Manager"

3. If you are still unable to access the TS Adapter IE via Ethernet, reset the configuration of

the TS Adapter IE using the P RES button.

NOTICE

If you reset the configuration of the TS Adapter IE, all the parameter settings you made

will be lost.

Repeat step 2.

If the TS Adapter IE is still not accessible via Ethernet, there is a hardware error. Inform

Customer Support in this case.