Specifications

SIMATIC Industrial Software Engineering Tools TS Adapter IE
Manual, 06/2008, A5E00977705-02
39
Commissioning
6
6.1 Overview
Commissioning options
In the factory state and after a parameter reset, the IP parameters of the TS Adapter IE are
set so that remote maintenance and e-mail are not possible.
The following table shows an overview of the various options for commissioning the
TS Adapter IE into operation:
Commissioning ... Step
... by direct connection via an
Ethernet connection
... via a remote connection with
TeleService
... via a remote connection without
TeleService
1 Set IP parameters by direct
connection:
• With TeleService
• With the SIMATIC Manager
Establish remote connection:
• With TeleService
Establish remote connection:
• By dial-up
2 Open configuration interface by
direct connection:
• With TeleService
• With a browser
Open configuration interface via a
remote connection:
• With TeleService
Open configuration interface via a
remote connection:
• With a browser
3
Configuration for remote maintenance or e-mailing
4
Carry out remote maintenance or send e-mail
For details on the individual commissioning tasks, refer to the subsections of the same
names in the "Working with the TS Adapter IE" chapter.