Technical data
Accessing Remote Plants (Remote Maintenance)
TeleService V6.1 Service Software for SIMATIC S7 and C7
A5E00921336-01
7-3
7.3 Using the Remote Connection with Micro/WIN
Requirement
After you have established a remote connection to a remote plant using
TeleService, you can work in the plant as usual with Micro/WIN.
This assumes you have correctly set the access point of the application
beforehand.
Proceed as follows:
1. Open the "Set PG/PC Interface" dialog box with the menu command
Options > Set PG/PC Interface.
2. Set the access point of the "Micro/WIN" application to the "TS Adapter" or
"TS Adapter IE" interface.
Use the "TS Adapter" interface for connections via a TS Adapter I/II and the
"TS Adapter IE" interface for connections via a TS Adapter IE.
Note
• Ensure that the "Access point of your application", "Micro/WIN" in this case, is
assigned the correct interface.
• If the access point is set to the "TS Adapter" interface, for example, because
you are currently accessing a plant with a TS Adapter I or II, the access point
must be reset to the "TS Adapter IE" interface before accessing a plant with a
TS Adapter IE.