Technical data

Configuring the TS Adapter I/II
TeleService V6.1 Service Software for SIMATIC S7 and C7
5-2 A5E00921336-01
5.3 Procedure for Configuring the TS Adapter I/II
You can configure the TS Adapter I/II with both a direct connection and a modem
connection via an established remote connection.
1. Select the menu command Options > Assign TS Adapter I/II Parameters.
The "Assign TS Adapter I/II Parameters" dialog box then opens.
2. Set the required parameters in the tabs of the dialog box.
3. Confirm your settings with "OK". The parameters are then saved in the non-
volatile memory of the TS Adapter I/II.
You can obtain detailed help about the individual options in the tabs by pressing
the
F1 key in the dialog box.
5.4 Switching between Direct and Modem Connections
with the TS Adapter I/II
Proceed as follows:
1. Select the menu command Options > Set PG/PC Interface.
2. In the "Access point of the application" list box, select, for example,
"S7ONLINE (STEP 7)" as the access point if you have installed STEP 7 or
"Micro/WIN" if you have installed MicroWin.
3. Select the "TS Adapter" interface in the "Used interface configuration" field.
Note that this changes the assignment in STEP 7 of the module with which
STEP 7 goes online.
4. Use the "Properties" button to define the further parameters for this interface.
Specify whether the TS Adapter I/II is to be operated with a modem or direct
connection.
5. If you have a direct connection with a TS>SP>Adapter I, also specify the local
COM connection of your programming device/personal computer to which the
TS Adapter is connected as well as the transfer speed between the
programming device/personal computer and the TS Adapter (19,200 bps or
38,400 bps).
If you have a direct connection with a TS Adapter II, select the "USB" setting.
6. Then confirm both dialog boxes by clicking on "OK".
Detailed help on "Set programming device/personal computer interface" can be
accessed by pressing F1 while you are positioned in the corresponding dialog box.
Note
TeleService functions are not supported by the PC/MPI cable and by the
PC Adapter.