Technical data

TeleService V6.1 Service Software for SIMATIC S7 and C7
A5E00921336-01
5-1
5 Configuring the TS Adapter I/II
5.1 Useful Information on Configuring the TS Adapter I/II
The TS Adapter can be configured both in direct connection mode as well as via an
existing remote connection.
Note
• If you change the current parameter settings when there is an established
remote connection, there is the risk that it will no longer be possible to
establish a modem connection with the modified parameters. In this case the
TS Adapter I/II can only still be configured in direct connection mode.
• This means that the configuration has to be carried out with a programming
device/personal computer at the site of the plant or that the TS Adapter I/II has
to be brought to the location of the local programming device/personal
computer in order to be configured.
Positive Acknowledgement
During configuration the data are written into the non-volatile memory of the
TS Adapter. The configuration process is not acknowledged positively until all
precautions have been taken to ensure that parameter changes have been carried
out correctly and thus survive a power failure.
Changes become effective for TS Adapter I/II as follows:
The serial parameters, the modem parameters and the parameters for the access
protection are activated after the remote connection has been disconnected.
The modified network parameters are activated immediately.
5.2 Overview of the Configuration Options for the
TS Adapter I/II
You have the following configuration options for the TS Adapter I/II:
• Procedure for Configuring the TS Adapter I/II
• Restoring the Default Configuration of a TS Adapter I/II
• Exporting Adapter Parameters for the TS Adapter I/II
• Importing Adapter Parameters for the TS Adapter I/II