Technical data

Basic Information about TeleService
TeleService V6.1 Service Software for SIMATIC S7 and C7
A5E00921336-01
3-11
Notes on Cabling the TS Adapter I
There is a 9-pin male connector on the optional null modem cable of the
TS Adapter. A suitable adapter may be required to connect to a COM port of the
programming device/PC.
The table below shows the cable connection at the programming device/PC.
Device: Connector: Cable connection:
Programming device COM 2 as 9-pin connector Additional zero-modem cable
Programming device COM 1 as 25-pin socket Additional adapter and zero-modem
cable
PC COM 1 or COM 2 as 9-pin connector Additional zero-modem cable
PC COM 1 or COM 2 as 25-pin connector Additional adapter and zero-modem
cable
Direct Connection with TS Adapter IE
The direct connection is used to configure the TS Adapter IE.
Establishing the Direct Connection for TS Adapter IE
The TS Adapter IE is connected directly to the Ethernet connection of the PG/PC.
No modem is required. The following figure shows the configuration with direct
connection of the TS Adapter IE.