Technical data

Basic Information about TeleService
TeleService V6.1 Service Software for SIMATIC S7 and C7
3-6 A5E00921336-01
3.4 How the TS Adapter I/II Works
Configuration
Depending on the configuration, the TS Adapter I/II connects the serial port or the
USB port of your programming device (direct connection) or the serial port of a
modem (modem connection) with the MPI/PROFIBUS network of your automation
system.
The TS Adapter I/II disposes of a non-volatile memory. Parameters for the
following functions are saved in this memory:
• The MPI/PROFIBUS network (network parameters)
• The operation of the modem used
• The serial interface to the Modem
• The access protection
Standard Configuration
The TS Adapter is supplied with a standard configuration. The parameters can be
set during a parameter configuration session and are written back to the non-
volatile memory of the TS Adapter.
In the direct connection configuration, the TS Adapter only uses the network
parameters for access to the MPI/PROFIBUS network.
In the modem connection configuration, all the parameters stored on the
TS Adapter are activated.
3.5 How the TS Adapter IE Works
Configuration
The TS Adapter IE connects the telephone network or the serial interface of a
modem to the Industrial Ethernet of your automation system.
The TS Adapter IE features non-volatile memory. Parameters for the following
functions are stored in this memory:
• The mode of the employed modem
• The serial interface to the modem
• The access protection