Technical data

Working with the TS Adapter II
5.4 Connecting the TS Adapter II
TS Adapter II
Manual, 06/2008, A5E00272728-03
39
Reset button
The TS Adapter II is equipped with a Reset button that you can use to reset the adapter
parameter assignment to the default parameter assignment. This may be necessary if the
adapter parameters in a remote system have been modified such that the TS Adapter II can
no longer be reached via the phone connection. In this case, the operator of the remote
system must hold the reset button down for approximately 2 seconds.
The DCD-LED of the TS Adapter II flashes three times to acknowledge that a reset operation
was performed remotely by means of the reset button. The TS Adapter II is then reset to the
default parameter assignment.

Figure 5-1 Front view with reset button
① Reset button