Technical data

Working with the TS Adapter II
5.3 Setting the PG/PC Interface
TS Adapter II
36 Manual, 06/2008, A5E00272728-03
5.3 Setting the PG/PC Interface
Procedure
During installation of the software you are prompted to set the PG/PC interface.
1. In the "Set PG/PC Interface" dialog, check whether the following interface parameter has
been assigned.
The selection list must contain the entry:
– TS Adapter
If this is not the case,
– click "Select..." to add/remove an interface. The "Install/Remove Interface" dialog box
opens.
– Select the "TS Adapter II" module from the selection list and install the adapter. Click
"Close" to close the dialog box.
2. In the "Set PG/PC Interface" dialog, select the interface parameter assignment that you
want to use in the future for communication (TS Adapter). Click the "Properties" button.
3. The "Properties - TS Adapter" dialog box opens. Open the "Local Connection" tab. Set
"USB" as the direct connection.
4. Click "OK" to close the "Properties - TS Adapter" dialog box.
5. Click "OK" to close the "Set PG/PC Interface" dialog box.
6. If you have changed an access path in these settings, a warning message then appears.
To apply the changes, click "OK".