Operating instructions

Operator controls and displays
5.5 Labeling the function keys on the MP 377 12" Key
MP 377, MP 377 PRO (WinCC flexible)
Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
87
Procedure
Proceed as follows:
1. Edit and then print the template.
You can also print blank templates and label them manually.
2. Apply a fixing spray film to the labeling strips.
The fixing spray ensures that the text is water resistant and does not smear, and that the
printer ink on the keyboard membrane does not run.
3. Cut out the labeling strip.
Ensure that the corners are cut according to the diagram shown above as this makes it
easier to slide them into the slot.
4. Remove any existing labeling strips.
Note
Wait for the printed labeling strips to dry before you insert them.
5. Slide the labeling strips ② into the slot ①.


6. Slide the labeling strips into the slot up to the stop.
The labeling strip will protrude approximately 3 cm from the slot. The template
dimensions for the labeling strips are designed so that the labeling is correctly placed for
the function keys. It is not necessary to secure the labeling strip.
When mounting the HMI device, ensure that the labeling strips do not become jammed
between the mounting cut-out and the HMI device.