Operating instructions

Mounting and connecting
4.2 Installing the HMI device
MP 377, MP 377 PRO (WinCC flexible)
56 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
Positioning the mounting clamps on the MP 377 15" Touch
The following figure shows the counting direction for the insertion of the mounting clamps.
The following table shows the positioning of the mounting clamps on the MP 377 15" Touch.
Observe the counting direction.
Page Number of
mounting clamps
Position 1 Position 2 Position 3 Position 4
Top 4 2 9 17 24
Right 3 3 10 17 –
Bottom 4 2 9 17 24
Left 3 3 10 17 –
Positions of the mounting clamps on the MP 377 19" Touch
The positions of the mounting clamps are marked by stamps on the cutouts.
The following diagram shows examples of these stamps.

① Stamps identifying the position of a mounting clamp
A total of 18 mounting clamps are needed for mounting. Fit mounting clamps in all the
stamped cutouts.