Operating instructions

Mounting and connecting
4.2 Installing the HMI device
MP 377, MP 377 PRO (WinCC flexible)
54 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
4.2 Installing the HMI device
4.2.1 Installing the MP 377 mounting device
Requirement
All packaging components and protective foils should be removed from the HMI device.
To install the HMI device, you need the mounting clamps from the accessory kit. The
mounting seal must be fitted on the HMI device. If the mounting seal is damaged, order a
replacement seal. The mounting seal is part of the associated service pack.
To ensure the necessary degree of protection on the HMI device, the mounting clamps must
observe the positions listed below.
The following photo shows how positions 1 to 10 are counted.



