Operating instructions

Planning application
3.2 MP 377 mounting devices
MP 377, MP 377 PRO (WinCC flexible)
Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
49
Dimensions of the mounting cutout
The following table shows the dimensions of the required mounting cutout:
Mounting cutout MP 377 12" Touch MP 377 12" Key MP 377 15" Touch MP 377 19" Touch
Width 310
+1
mm 450
+1
mm 367
+1
mm 449
+1
mm
Height 248
+1
mm 290
+1
mm 289
+1
mm 379
+1
mm
HMI device depth,
not including front
panel
72 mm 59 mm 72 mm 75 mm
Note
You can insert an MP 377 12" Key into the mounting cutout of the following HMI devices:
• MP 370 12" Key
• MP 277 10" Key
• MP 270 10" Key
• OP 270 10"
You can insert an MP 377 12" Touch into the mounting cutout of the following HMI devices:
• MP 370 12" Touch
• MP 277 10" Touch
• MP 270 10" Touch
• OP 270 10"
You can insert an MP 377 15" Touch into the mounting cutout of the following HMI device:
• MP 370 15" Touch
Maintaining clearances
The HMI device must be installed with the following clearances:
● 50 mm above and below the mounting cutout respectively for ventilation
● 15 mm to the right and left of the mounting cutout respectively for suspending the
mounting clamps for mounting
● At least 10 mm behind the rear panel of the HMI device
NOTICE
Ensure that the maximum ambient temperature is not exceeded when mounting the
device in a cabinet and especially in a closed enclosure.