Operating instructions

Operating a project
8.9 Operating the slider control
MP 377, MP 377 PRO (WinCC flexible)
Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
215
Procedure using the touch screen
Proceed as follows:
1. Touch the slider of the desired slider control.
2. Move the slider to the required value.
If a value display has been configured, you can check the exact value that has been set.
3. Release the slider.
Key control
The following table shows the control keys used to set the slide to a desired value:
Key combination Description
SHIFT
+ or
SHIFT
+
Increase value by 1
SHIFT
+ or
SHIFT
+
Reduce value by 1
HOME
Increase value in 5% increments.
END
Decrease value in 5% increments.
F
N
+
HOME
Set maximum value
F
N
+
END
Set minimum value
Procedure using the keys
Proceed as follows:
1. Using the key
TAB
mark the desired switch within the screen.
2. Move the slider to the required value.
If a value display has been configured, you can check the exact value that has been set.
Result
The set value is applied.