Operating instructions

Operating a project
8.9 Operating the slider control
MP 377, MP 377 PRO (WinCC flexible)
214 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
Touch operation
Touch the required button in the trend view.
The position of the ruler can also be changed by means of touching and dragging the ruler
on the touch screen.
Procedure using the keys
Proceed as follows:
1. Using the key
TAB
select the desired button within the trend view.
2. Confirm your entry by pressing the key
ENTER
.
8.9 Operating the slider control
Introduction
The slider control can be used to monitor and change process values within a defined range.
The slider control can also be configured without a slider. In this case, you cannot enter a
value. The slider control is then only used for displaying values.


① Slider control for entering values
② Value display with current value
Layout
The layout of the slider control depends on the configuration:
● The slider control can contain a label and a setting range
● The current value can be displayed below the area of the slider control