Operating instructions

Commissioning a project
7.3 Using existing projects
MP 377, MP 377 PRO (WinCC flexible)
Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
161
7.3 Using existing projects
The following table shows how you can reuse existing projects, while observing
the screen size:
HMI device in the existing project New HMI device
MP 370 12" Touch MP 377 12" Touch
MP 370 12" Key MP 377 12" Key
MP 370 15" Touch MP 377 15" Touch, MP 377 PRO 15" Touch
The following cases are possible:
1. Project exists in ProTool
Migrate the project to WinCC flexible and then replace the HMI device.
2. Project exists in WinCC flexible
Carry out an HMI device switch in WinCC flexible.
If you migrate existing projects from HMI devices with a different screen size, images which
have already been configured are converted during the migration.
Further information on the subject can be found in the WinCC flexible Online Help or in the
"WinCC flexible Migration" manual.