Operating instructions

Configuring the operating system
6.17 Restoring from external storage device
MP 377, MP 377 PRO (WinCC flexible)
Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
157
5. The data to be restored is checked.
The following messages are displayed in sequence during the check.
– "Starting Restore"
– "Checking data"
When the data has been checked, the following message is displayed:
"You are starting RESTORE now. All files (except files on storage cards) and the registry
will be erased. Are you sure?"
The message means that the restore process can be started. All files files except
those located on the external memory will be deleted. Tab entries are also deleted.
Are you sure?
6. If you do not want to allow the data to be deleted from the HMI device, abort the restore
process by pressing the "ESC" button.
7. Start to restore the data by selecting "Yes".
The following messages are displayed in sequence during the restore:
– "Deleting files on flash"
– "Restore CE Image"
A progress bar shows the status of the restore process.
When restore is completed, the following message is displayed:
"Restore succesfully finished. Press ok, remove your storage card and
reboot your device."
8. Remove the external memory.
9. Acknowledge this message.
The HMI device starts.
Result
The data from the external memory is now on the HMI device.
Note
Calibrating the touch screen
After the reset, you may have to recalibrate the touch screen.