Operating instructions

Configuring the operating system

6.15 Configuring network operation

MP 377, MP 377 PRO (WinCC flexible)

146 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0

Procedure

Proceed as follows:

1. Open the "ERTEC400" entry.

The "'ERTEC400 Ethernet Driver' Settings" dialog is opened.

2. If you need automatic issuing of addresses, select the "Obtain an IP address via DHCP"

radio button.

3. If you need manual issuing of addresses, select the "Specify an IP address" radio button.

4. If you have selected manual issuing of addresses, enter the corresponding addresses in

the "IP Address", "Subnet Mask" text boxes and if necessary in "Default Gateway".

5. If a name server is used in the network, change to the "Name Servers" tab.

6. Enter the respective addresses in the text boxes.

7. Confirm your entries.

The dialog closes.

8. Close the "Network&Dial-Up Connections" display.

The Control Panel is displayed again.

Result

The LAN connection parameters for the HMI device have been changed.