Operating instructions

Configuring the operating system

6.14 Changing transfer settings

MP 377, MP 377 PRO (WinCC flexible)

138 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0

Procedure

Proceed as follows:

1. If you want to enable a data channel, activate the "Enable Channel" check box in the

"Channel 1" or "Channel 2" group.

In the "Channel 1" group, the RS-422/RS-485 port is enabled for the serial data transfer.

The network port is enabled in the "Channel 2" group.

2. If you want to enable the automatic transfer, activate the associated "Remote Control"

check box.

3. If you have enabled the data channel for "Channel 2", select the log from

the selection box.

4. Enter further parameters if required.

Applies to "MPI/PROFIBUS DP":

– Press the "Advanced" button to switch to the "S7-Transfer Settings" dialog box.

You can change the settings for MPI/PROFIBUS DP there.

– Confirm your entries.

– The "S7-Transfer Settings" dialog box closes.

Applies to "ETHERNET":

– Use the "Advanced" button to change to "Network&Dial-Up Connections".

– Open the "ERTEC400" entry. You can change the TCP/IP settings there.

– Confirm your entries.

– Close "Network&Dial-Up Connections".

Applies to "USB":

– No settings are needed for "USB".

5. Confirm your entries.

The dialog closes.

Result

The data channel is configured.