Operating instructions

Configuring the operating system

6.10 Setting the delay time

MP 377, MP 377 PRO (WinCC flexible)

Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0

131

6.10 Setting the delay time

Introduction

Once the HMI device has been switched on, a project can be started after a delay. The

Loader is displayed during the delay time.

Requirements

You have opened the "Transfer Settings", dialog "Directories" tab with

the "Transfer"

icon.

NOTICE

Settings under "Project File" and "Path"

The project may not open the next time the HMI device is started if changes are made in

the "Project File" and "Path" text boxes.

Do not change the entries in the "Project File" and "Path" text boxes.

Procedure

1. Select the desired delay time in seconds from the "Wait [sec]" selection box.

With the value "0", the project starts immediately. It is then no longer possible to call the

Loader after switching on the HMI device. If you still wish to access the Loader, an

operating element must be configured to close the project.

2. Confirm your entries.

The dialog closes.

Result

The delay time for the HMI device is now set.