Operating instructions

Configuring the operating system
6.9 Setting storage location
MP 377, MP 377 PRO (WinCC flexible)
130 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
6.9 Setting storage location
Introduction
There are various storage locations available for storing the compressed source file of your
project. The following describes how you can set the storage location.
Requirements
You have opened the "Transfer Settings", dialog "Directories" tab with
the "Transfer"
icon.



① Directory where the project file is saved
② Directory where the compressed source file of your project is saved
③ Storage location and initialization file of the HMI device for process operation
NOTICE
Settings under "Project File" and "Path"
The project may not open the next time the HMI device is started if changes are made in
the "Project File" and "Path" text boxes.
Do not change the entries in the "Project File" and "Path" text boxes.
Procedure
1. Select a memory location from the "Project Backup" text box.
The external memory card or the location in the data network can be defined as the
storage location. During the next backup process, the project's source file is stored in the
specified location.
2. Confirm your entries.
The dialog closes.
Result
The storage location for the HMI device is now set.