Operating instructions

Configuring the operating system

6.8 Changing HMI device settings

MP 377, MP 377 PRO (WinCC flexible)

Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0

127

6.8.10 Displaying information about the HMI device

Introduction

You will need the device-specific information if you contact Technical Support.

Requirement

You have opened the "OP Properties" dialog box, "Device" tab, by touching

the "OP"

icon.

The following figure applies to the MP 377 15" Touch. The data displayed are device-specific

and may therefore deviate from that of your HMI device.















① HMI device name

② Version of the HMI device image

③ Version of the boot loader

④ Boot loader release date

⑤ Size of the internal flash memory in which the HMI device image and project are stored

⑥ MAC address of the HMI device

⑦ See section "Restarting HMI device"

The HMI device-specific information is displayed in the "Device" tab.

Note

The size of internal flash memory is not equivalent to application memory available for a

project.