Operating instructions

Configuring the operating system
6.8 Changing HMI device settings
MP 377, MP 377 PRO (WinCC flexible)
124 Operating Instructions, 10/2008, 6AV6691-1DR01-0AB0
6.8.8 Assigning sound to an event
Introduction
When acoustic feedback is activated, a sound is used to report an event. You can select the
sound to reflect the event.
Requirements
● A loudspeaker is connected to the HMI device.
● You have opened the "Volume & Sounds Properties", dialog "Sound" tab with
the "Volume & Sounds"
icon.
Procedure
Proceed as follows:
1. Select a suitable sound from the "Event" group.
The sound selected is displayed in the "Sound" group in the associated list box.
2. If you want to listen to the sound, press the "
" button.
The sound is output by a loudspeaker connected to the HMI device. Use the
button
to stop the output.
3. If you haven't managed to find a suitable sound, you can use the "Browse" button to
switch to a folder of your choice.
The sound selected is displayed in the "Sound" group in the associated list box.
4. Confirm your entries.
The dialog closes.
Result
The sound is set for acoustic feedback on operations.