Operating instructions

Expansion and parameter assignment
10.3 Installing PCI/PCIe cards
SIMATIC IPC627C
Operating Instructions, 11/2010, A5E02669068-02
69
Inserting the slider
Proceed as follows when using the slider:
How to install a slider
1 Push the slider through the guide
slot until it is seated firmly on the
module. Insert the module into the
slot.
CAUTION
Do not put pressure on the module! Do not apply excessive force on the slider when you
push it onto the module.
2 Cut off the rest of the slider
element: Use a knife to apply a
cut on the slider at the upper
edge of the bracket and then
break this section off. Cut off
the residual element using a
side cutter.
Notes on the allocation of resources
The two slots for the PCI cards each have an exclusive interrupt. You will find information on
the assignment of the PCI IRQ line to the PCI slot in the section " or section Bus board
(Page 144).