Operating instructions

Description
3.5 Features
SIMATIC IPC627C
16 Operating Instructions, 11/2010, A5E02669068-02
Basic data
Drives and storage media
Mass storage
 1 x 3.5" hard disk or
 2 x 2.5" hard disk or RAID1 system
Capacity see order forms
DVD drive DVD burner
Flash memory
 Slot for Compact Flash card
 1 x Solid State Disk
Interfaces
Ethernet 2x 10/100/1000 Mbps (RJ45)
PROFIBUS/MPI 12 Mbps (isolated potential, compatible to CP 5611),
optional
PROFINET 10/100 Mbps (CP 1616 onboard), three RJ45; optional
USB
 External: 4 x USB 2.0 high current
(max. 2 can be simultaneously operated as high current)
 Internal: 1 x USB 2.0 high current + 1x USB 2.0 low
current on a 10-pin male connector, 1 x USB 2.0 low
current for internal USB stick/dongle
 Front panel ports: 1 x USB 1.1, 1 x USB 2.0,
both high current
COM Serial V.24 port
Monitor 1x DVI-I (VGA monitors can be connected with a DVI/VGA
adapter that is available as an accessory)
Monitoring and safety functions
Temperature
 When permitted temperature range is exceeded
 Warning messages from application program that can
be analyzed: local (DiagBase), via LAN (DiagMonitor,
optionally available)
Fans
 Failure of device and power supply fans
 Warning messages from application program that can
be analyzed: local (DiagBase), via LAN (DiagMonitor,
optionally available)
Watchdog
 Monitoring function for program execution
 Restart can be parameterized in the event of a fault
 Warning messages from application program that can
be analyzed: local (DiagBase), via LAN (DiagMonitor,
optionally available)
LED display 2 LEDs for displaying system status that can be
programmed by the user
1
Transient voltage interruption Up to 20 ms buffer time with full load
Buffer memory (optional) 2 MB battery-buffered SRAM
1) 2)
1)
The DMAPI programming interface is available to activate the LEDs and the SRAM
2)
. You
will find this in the folder "C:\Program Files\Siemens\DiagnosticManagement\DMAPI".
2)
only with devices with PROFIBUS or PROFINET interface