User manual

3-1
Distributed I/O System DP/ASi Link
EWA 4NEB 710 6055-02b
Configuration Options
At this point we will show you how you integrate the DP/ASi link into the
PROFIBUS-DP, and what you have to bear in mind when you do so.
The power supply (PS) described in this chapter is the 24 VDC power supply
of the DP/ASi link, which is required to operate it.
If you are already familiar with the configuration options of the PROFIBUS-
DP – for example, from the Distributed I/O System ET 200C manual, you can
skip this chapter.
In this chapter we take a look at the PROFIBUS-DP side of the DP/ASi link.
In Section You Will Find on Page
3.1 Summary of Configuration Options 3-2
3.2 Configuration without T Connector and with Power Supply
Connector
3-3
3.3 Configuration with T Connector and with Power Supply
Connector
3-4
3.4 Configuration with Several Power Supply Connectors 3-6
3.5 Configuration without Power Supply Connector 3-7
3.6 Configuration with Programmer Connector 3-9
Introduction
Tip
In this chapter
3