User manual

D-1

Distributed I/O System DP/ASi Link

EWA 4NEB 710 6055-02b

Configuration Message

You require this section only if you are not using an application such as COM

ET 200 Windows.

The DP/ASi link requires the configuration message during start-up. This

chapter describes the structure of the configuration message for the DP/ASi

link used as a DP standard slave.

The configuration message defines the length of input and output data. They

are compared with the data contained in the parameterization message.

In Section You Will Find on Page

D.1 Structure of the Configuration Message with a Default

Start-Up

D-2

D.2 Structure of the Configuration Message in Configuration

with Address Optimization

D-3

D.3 Structure of the Configuration Message in Simple Configu-

ration

D-7

Tip

Introduction

Meaning

In this appendix