Specifications

ManualsBrandsSiemens ManualsComputer equipmentSIMATIC Distributed I/O System DP/ASi Link

Systems

Introduction

2/3

Siemens LV 1 · 2007

Order No. Page

EMERGENCY-STOP front

plate

AS-Interface EMERGENCY-STOP pushbuttons

• Degree of protection IP65/IP67

• EMERGENCY-STOP directly on AS-Interface using integrated modules

• Metal or plastic version

Your advantage: Easy direct connection of service-proven operator controls to ASIsafe

3SF5 Ch. 9

Masters

The AS-Interface master creates the connection to higher-level control systems. It

automatically organizes the data traffic on the AS-Interface cable and sees not only

to querying the signals but also to performing the parameter setting, monitoring and

diagnostics functions.

CP 343-2 P for

SIMATIC S7-300

CP 243-2 for

SIMATIC S7-200

Masters for SIMATIC

• Connection of up to 62 AS-Interface slaves

• Integrated analog value transfer

• Configuring and uploading of AS-Interface configuration in STEP 7 with S7-300 Master

• No configuration required

• Easy operation in the input/output address range

• Monitoring of the supply voltage on the AS-Interface shaped cable

Your advantage: Easy connection to SIMATIC S7-300, to SIMATIC S7-200 or

to SIMATIC ET 200X

6GK7 2/17

AS-Interface / Routers

As an alternative to the CPs, which are plugged directly in the controller it is also

possible to use a gateway/link as AS-Interface master – at any position beneath the

PROFIBUS DP or Industrial Ethernet.

IE/AS-i LINK PN IO

DP/AS-i LINK Advanced

DP/AS-Interface Link 20E

Routers

• Degree of protection IP20

• PROFIBUS slave or PROFINET IO device and AS-Interface master (single or double

master in case of DP/AS-i LINK Advanced and IE/AS-i LINK PN IO)

• Connection of up to 62 AS-Interface slaves

• Integrated ground-fault monitoring (in case of DP/AS-i LINK Advanced and

IE/AS-i LINK PN IO)

• User-friendly local diagnostics and local start-up by means of a full graphic display

and control keys or through a web interface with a standard browser (in case of

DP/AS-i LINK Advanced and IE/AS-i LINK PN IO)

• No configuration of the CP for AS-Interface required

• Integrated analog value transfer

• Configuring and uploading of AS-Interface configuration in STEP 7 possible

• User-friendly selection of AS-Interface slaves

Your advantage: Optimum transition to PROFIBUS or Industrial Ethernet, integrated in

STEP 7

6GK1 2/21