Technical data

Safety information

This manual contains information which you must observe for your personal safety and to

prevent material damage. The information is denoted by a warning triangle and is represented

as follows, depending on the degree of endangerment:

Warning

means that death, serious injury or considerable material damage can result, if the appropriate

safety precautions are not taken.

Caution

means that slight injury or material damage can result, if the respective safety precautions are

not taken.

Note

is an important piece of information about the product, the handling of the product or the

respective part of the documentation which should be noted in particular.

Qualified personnel

Only qualified personnel may make changes to the device on the basis of the technical

description. Qualified personnel are persons, who have the authorisation to install, ground and

label, devices, systems and circuits in accordance with the standards of safety engineering.

As directed use

Please note the following:

Warning

The device may only be used for the application cases specified in the catalogue and the

technical description and may only be used in combination with extraneous equipment and

components recommended or approved by Siemens.

Appropriate transport, appropriate storage, installation and assembly as well as careful

operation and maintenance are required to ensure that the product operates perfectly and

safely.

Trademarks

SIMATIC, SIMATIC HMI  and SIMATIC NET are registered trademarks of Siemens AG.

The remaining marks in this publication may be trademarks, whose use by third parties for their

own purposes could violate the rights of the owner.

We have checked the content of this publication for compliance with the

described hard- and software. However, discrepancies cannot be

excluded, with the result that we assume no guarantee for total

compliance. The information in this publication is checked regularly, and

any necessary corrections are included in the following editions. We

would be grateful for any suggestions for improvement

The transmission and reproduction of this documentation and the

exploitation and communication of its contents are not allowed,

unless expressly granted. Contraventions are liable to

of the granting of a patent or registration by GM.

Siemens AG

Bereich Automatisierungs- und Antriebstechnik

Geschäftsgebiet Industrie-Automatisierungssysteme

Postfach 4848, D- 90327 Nürnberg

 Siemens AG 2000

Subject to technical change.

Siemens Aktiengesellschaft C79000-G7076-C639