Technical data

Configuring the SIMATIC Box PC 620
6-10
SIMATIC Box PC 620 Manual
C79000-G7076-C639-02
Option ”Boot Options”
The following submenu appears when you select the option “Boot Options” in the
main menu:
PhoenixBIOS Setup-Utility
Item Specific Help
ESC Exit
Select Item
Select Menu
+ / –
Enter Select
Change Values F9
F10
Setup Defaults
Save and Exit
Sub-Menu
QuickBoot Mode:
SETUP prompt: [Enabled]
Main
Boot Options
[Enabled]
Allows the system to skip cer-
tain tests while booting. This
will decrease the time needed
to boot the system.
POST Errors: [Enabled]
Floppy check: [Disabled]
Summary screen: [Enabled]
F1 Help
Figure 6-5 ”Boot Options”Submenu
Quick Boot
Mode
Some hardware tests are skipped to speed up the boot procedure.
SETUP prompt The message PRESS <F2> to enter Setup appears at the bottom of the
screen during the system run-up phase.
POST Errors The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter “Disabled”to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.