Data Sheet for Product

CK1N9836en

21.03.2001

Siemens Building Technologies

Landis & Staefa Division

836

SICLIMAT™

Uninterruptible Power

Supply

USV

Ensures an uninterrupted supply of power to the SICLIMAT X-OS operator station

in the event of mains interference or power failure.

Use

The single-phase USP is simply connected between the mains supply and the electrical

load. The standard serial port is used for communication with the X-OS. The USPs are

the "on-line" type, i.e. the connected electrical loads are powered continuously by the

USP, isolated from any mains interference and free of interruption.

In normal operation a rectifier converts the AC mains voltage into a DC voltage which

supplies the electrical energy for the inverter. At the same time, the internal battery is

kept fully charged.

The inverter powers the connected loads with a very stable sinusoidal AC voltage. With

extreme long-term overload or load short-circuits, the system switches to the internal

bypass. This happens when the output-voltage tolerances are exceeded (change-over

criterion).

Visual and audible alarms indicate the current operational status, which is transferred to

the connected computer via the integral computer port. With a partially discharged

battery, an audible warning is triggered when the remaining hold-up time (at nominal

load) drops to only 3 minutes.

PAGE 1
9 836 SICLIMAT™ Uninterruptible Power Supply USV Ensures an uninterrupted supply of power to the SICLIMAT X-OS operator station in the event of mains interference or power failure. Use The single-phase USP is simply connected between the mains supply and the electrical load. The standard serial port is used for communication with the X-OS. The USPs are the "on-line" type, i.e.
PAGE 2
Connecting the X-OS to the USP It is strongly recommended that every X-OS should be connected to a USP. This ensures an uninterrupted power supply during normal operation. In the event of mains interference, brief interruptions are fully covered by the USP. Longer-lasting mains interruptions lead to an orderly shut-down of the X-OS to prevent the loss of data. The response times can be defined by the user. The required software is part of the basic SICLIMAT X software package.
PAGE 3
Technical data Data Type Communications software Battery Nominal power (where cos ϕ = 0.7ind) Hold-up time at nominal load Hold-up time at half load Overload capability Power supply Input (single phase) Voltage range Frequency Output (single-phase) Voltage and frequency Frequency tolerance Total harmonic distortion (THD) Efficiency Min.
PAGE 4
/4 Siemens Building Technologies Landis & Staefa Division ã 2001 Siemens Building Technologies Ltd. Uninterruptible Power Supply Subject to changes CK1N9836en 21.03.