User Manual

ManualsBrandsSiemens ManualsBuilding automationAPOGEE® Building Automation

903

SICLIMAT™ X

Link to connect SIMATIC

S5-Link

The S5 Link is used by SICLIMAT X to exchange existing computers to connect

SIMATIC S5, PRU and COMPAS to X-OS.

It is capable of connecting PROFIBUS, SINEC L1 and Industrial Ethernet using

the widest possible array of protocol (TF, FMS, FMS-GA) via the terminal bus

(TCP/IP) to the X-OS, based on the latest computer generation.

CK1N9903en

01.08.2007

Building Automation

Siemens Building Technologies

Summary of content (4 pages)

PAGE 1
9 903 SICLIMAT™ X Link to connect SIMATIC S5 S5-Link The S5 Link is used by SICLIMAT X to exchange existing computers to connect SIMATIC S5, PRU and COMPAS to X-OS. It is capable of connecting PROFIBUS, SINEC L1 and Industrial Ethernet using the widest possible array of protocol (TF, FMS, FMS-GA) via the terminal bus (TCP/IP) to the X-OS, based on the latest computer generation. CK1N9903en 01.08.
PAGE 2
Application All SIMATIC S5, PRU and COMPAS may only be operated in the future via the S5 Link when exchanging computers. Three ISA modules can be plugged in (limited combinations possible).
PAGE 3
Configuration Example: two PROFIBUS lines using SIMATIC S5 and COMPAS WEB Ethernet TCP/IP X-OS S5-Link PROFIBUS TF COMPAS PROFIBUS TF SIMATIC S5 COMPAS SIMATIC S5 Performance characteristics The S5 Link is based on a compact, industrial PC (width 254 mm, height 175 mm, depth 410 mm) in IP class 21 Up to 3 bus lines (3 PCCs) can be connected to the S5 Link. Generally, existing circuitry from the computer to be replaced is taken out and plugged into the S5 Link.
PAGE 4
Engineering The S5 Link is supplied with a preset IP address which may be changed once to use it in a plant via the serial interface (COM1). Access via the serial interface takes place using a null modem cable and a terminal or terminal emulation on the PC. An IP address is set at the plant, if entered when ordering. No change required on site. S5 Link is then recognized in the Ethernet and the engineering parameter, existing on the X-OS, can be loaded once from there to the S5 Link.