Data Sheet for Product

5/8
Siemens Elctromotoric Actuators CA1N4865en
Building Technologies 2021-07-16
Commissioning
• Check the wiring.
• Check the functioning of the actuator and of the auxiliary switch, if fitted.
The valve can be opened manually by use of a lever on the actuator. When the valve is
approximately 90% open this locks into position. When electrical operation is resumed,
the locking mechanism is released automatically.
Opening the valve manually Locking the lever into position at a
valve opening of approx. 90%
01600
01602
Releasing the lever manually
01601
Rotate lever as far as the mechanical stop, and release.
Maintenance
• The actuators require no maintenance.
• In the event of a fault, the actuator can be replaced without removing the valve. The
operating voltage must be switched off during this process.
• The actuators cannot be repaired.
Disposal
The device is considered electrical and electronic equipment for
disposal in terms of the applicable European Directive and may not be
disposed of as domestic garbage.
• Dispose of the device through channels provided for this
purpose.
• Comply with all local and currently applicable laws and
regulations.
Warranty
The technical data given for these applications is valid only when the valves are
used with the actuators described under "
Equipment combinations", page 2.
The use of type SFP.. actuators with third-party valves invalidates any warranty
offered by Siemens.
Operating
Manual adjustment