Installation Instructions

Document No. 129-705
Installation Instructions
May 10, 2016
Page 2 of 5 Siemens Industry, Inc.
Installation
Remove the Existing SED2 Drive
1. Disconnect power.
WARNING:
Always wait five minutes after disconnecting
the SED2 from the power source before
performing any work.
2. Remove right side and lower covers from existing
SED2 Drive to expose power and control wiring.
3. Disconnect existing power and control wiring from
the SED2 Drive.
4. Remove and retain two screws from both ends of
existing 994-944-01 Cover.
5. Remove and discard the 994-944-01 Cover from
the 994-943 Stand.
6. Pull existing power and control wiring from the
existing SED2 Drive into the 994-943 Stand
cavity.
7. Remove four nuts and washers from the SED2
Drive mounting studs.
8. Remove the 994-001 Dust Cover and SED2
Drive from the bypass.
Figure 2. Remove Existing SED2 Drive.