Installation Instructions

Document No. 129-704
Installation Instructions
May 10, 2016
Siemens Industry, Inc. Page 5 of 7
Figure 18. Grommets, Installed.
Wiring the BT300 HVAC Drive
1. Terminate the input and output power wires and
ground at the BT300. Trim and strip wire as
needed. (For Frame Size 6 BT300, shorten
power wires by two inches [51 mm]), as
required.
Figure 19. Terminated BT300 HVAC Drive Wires.
2. Reinstall the Cable Protection Plate.
Figure 20. Cable Protection Plate.
3. Connect the control wiring and use cable ties to
secure to the Cable Protection Plate. See Table
1.
Figure 21. Cable Protection Plate.