Installation Instructions

Document No. 129-704
Installation Instructions
May 10, 2016
Siemens Industry, Inc. Page 3 of 7
Figure 8. SED2 Drive Control Wiring.
5. Using a large Phillips screwdriver, remove the
drive mounting screws (save for re-use) and
remove the SED2 Drive and protective shield
from the backplane.
Figure 9. SED2 Drive and Protective Shield Removed.
NOTE: Dispose of electronic materials properly.
Mounting and Wiring the Terminal Block
Assembly
1. Mount the Drive Adapter Plate reusing the four
drive mounting screws saved when the SED2
Drive was removed.
Figure 10. Drive Adapter Plate.
2. Slide the Drive Enclosure Bracket into place.
Figure 11. Drive Enclosure Bracket.
3. Install the pre-wired terminal block assembly
onto the Drive Enclosure Bracket, with wires
facing up.
4. Secure with four 10-32 screws and nuts
(included in Hardware Kit).
Figure 12. Terminal Block Assembly, Secured.
5. Separate the ground wire from its harness, if
required.
6. Remove the crimped end from the ground cable
and use a wire stripper to strip 3/8" from the
end, if required.