Installation Instructions

Document No. 129-706
Installation Instructions
May 10, 2016
Siemens Industry, Inc. Page 3 of 6
Mounting and Wiring the Terminal Block
Assembly
1. Slide in the Drive Enclosure Bracket. Use a
large Phillips screwdriver and the remaining two
drive mounting screws to secure in place. See
Figure 7 and Figure 8.
Figure 7. Drive Enclosure Bracket.
Figure 8. Finished Assembly.
2. Install the terminal block assembly onto the
Drive Enclosure Bracket studs, with the ground
terminal to the right.
Figure 9. Terminal Block Assembly.
3. Using a 3/8" socket, secure with 10-32 nuts
(included in hardware kit).
4. Separate the ground wire from its harness, if
required.
Figure 10. Ground Wire.
5. Remove the crimped end from the ground cable
and use a wire stripper to strip 3/8" from the
end, if required.
6. Terminate existing bypass wiring (control,
power, and ground) to the bottom edge of the
terminal block assembly. See Figure 11 and
Table 1.
Figure 11. Terminated Bypass Wiring.