Installation Instructions

Document No. 129-703
Installation Instructions
May 10, 2016
Siemens Industry, Inc. Page 5 of 7
Mounting the BT300 HVAC Drive
NOTE: See Installation Instructions (DPD01148)
(Included with unit) for more complete
instructions.
1. Using a large Phillips screwdriver, loosen the
cover screws and remove cover from the BT300
HVAC Drive.
Figure 15. BT300 HVAC Drive with Cover Removed.
2. Using the M5 grounding screw from the Drive
Accessory Kit, install the ground cable onto the
ground connection of the drive.
Figure 16. Ground Cable, Installed.
3. Mount the BT300 to the Drive Mounting Plate
using four 1/4-20 hex nuts with flat washers
(included in the Hardware Kit).
Figure 17. BT300 Mounted to the Drive Mounting
Plate.
4. Remove the Cable Protection Plate from the
BT300 HVAC Drive.
Figure 18. Cable Protection Plate.
5. Using a knife, slice two grommets to allow for
wiring to pass through. Install three grommets to
the BT300 Drive, positioning the sliced
grommets into the side openings.
Figure 19. Grommets, Installed.